Indesit Dishwasher No Heat

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Indesit Dishwasher No Heat

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 14, 2010 at 11:48 pm #52495
    subs
    Participant

    IDL 40UK C S/N605228126
    Heater and cut out stat ok. When i checked it on quick wash, at start of wash there is power through heater for about 10- 15 seconds and then the neutral path stops. If i open the door and and close it again the wash starts again and the same thing happens. Wires at bottom of door seems ok. Does this sound like a board fault? (checked board no dry joints etc).
    What does the pressure switch on sump hose do? Is it anything to do with heater, ie heater cuts out due to low water level? Also how does it sense temp, could not find sensor?

    Thanks

    Subs

    February 15, 2010 at 12:23 am #312040
    Penguin45
    Participant

    Re: Indesit Dishwasher No Heat

    Sounds like the relay on the pcb is dropping out under load. If the h/p switch wasn’t working, you’d get the blocked filter error.

    Chris.

    February 22, 2010 at 12:15 pm #312041
    subs
    Participant

    Re: Indesit Dishwasher No Heat

    New board cured fault.

    Thanks

    Subs

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.