hotpoint ff187m

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint ff187m

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 16, 2010 at 8:42 am #52529
    Johnnyboy
    Participant

    hi all
    have a problem with a ff187 complaint internal light flashing when door was opened took this as a warning ,ordered top fascia pcb
    but sadly fault still persists does this pcb need programmed or can any shed any light on this fault (have noticed that their is another module at the base of the appliance) thanks for any advice

    February 16, 2010 at 9:04 pm #312161
    geoff1
    Participant

    Re: hotpoint ff187m

    hI

    With this unit the internal light flashes after the door has been opened for more than 2 mins.
    Check that the light switch is being activated by running a magnet along control panel to see if light goes out. there should be a reed switch built into control panel and a magnet into door.

    Hope this helps

    Geoff

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.