- This topic has 3 replies, 4 voices, and was last updated 16 years, 1 month ago by
.
-
Posts
-
which kit do you find the best value?
buying separately each component of the drum running gear is expensive, so which would work out the best value for me where for example i usually use 4 bearer pads, a belt and a square or teardrop bearing. everything else is generally ok. to not replace either the bearer pads or bearing is in my mind somewhat megligent if they show wear, but if i bought them separately they work out far too expensive for a customer to want to go ahead with the repair.
Re: best way to get hold of hotpoint/indesit/creda td spares
I usually buy the shaft kit 1703080. That comes with square and teardrop bearings, the front pads and front and rear felts.
Re: best way to get hold of hotpoint/indesit/creda td spares
Same here, its listed as being for the vented dryer but will fit the condensor as well. Much cheaper than buying the bits individually and you can keep the bits you don’t use such as the rear bearing etc for future jobs.
Jim.
- You must be logged in to reply to this topic.