- This topic has 2 replies, 2 voices, and was last updated 16 years ago by
.
-
Posts
-
Hi guys! I have a Rangemaster 110 Green to go to tomorrow with a thermostat and switch to change. Its the model with the solid rings on top and the warming plate on the right. I seem to recall having problems getting the lid up on these in the past, i.e. I remember there being two nut and bolts either side at the front holding the top down? Can anyone give any advice on the easiest way to attack this, whether there is a way to get to the bolts or if you get in from the side panels?
Help would be greatly appreciated if anyone can remember how to tackle these.
Regards,
AndystuRe: Rangemaster change thermostat and switch.
remove 4 screws on hotplate (on top) remove 2 screws on the grill plate ( right hand side under griddle plate…remove 2 large screws rear of solid hotplate (about an inch uners hotplate top)…remove 2 screws in griddle plate rear ( actually go into the spillage tray)…slide griddle plate assy to the right…and move it back (may have to release earth wire)
hotplate will ift straight up and off. then access the bezel by removing all screws around it…( but not the timer screws) pull it off and bobs ya uncle!!Jazz!!
Ps.. reverse of above to re-assemble!! 😆
- You must be logged in to reply to this topic.