hoover oph714d

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hoover oph714d

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • April 4, 2010 at 5:15 pm #53779
    LittleMan
    Participant

    Hi customer has phoned and said that this machine did not drain and was giving fault code E3 they cleaned out pump and it is giving code E16
    Can any one help please
    Les

    April 4, 2010 at 8:00 pm #317201
    A1engineer
    Participant

    Re: hoover oph714d

    E16 is a wash heater fault 😉

    April 4, 2010 at 8:34 pm #317202
    helo_75
    Participant

    e3 is a heater fault on that too

    theres a memo about the heater being down enough to make the board think its still full

    April 6, 2010 at 5:45 pm #317203
    LittleMan
    Participant

    Re: hoover oph714d

    called on this customer today machine worked ok but took 2min to drain only tried rinses and spin customer doing full load to night , do you think the drain time is too long.
    Les

    April 6, 2010 at 8:28 pm #317204
    Penguin45
    Participant

    Re: hoover oph714d

    Yes. Coin in pump inlet is always a good one.

    Chris.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.