Hotpoint wf321

Re: Hotpoint wf321

Gordy. Theres a good chance it has burnt out the main Board, I believe this are known as the series 4 board or series 8 Board, at the back. The series 8 usually has a big heat sink on it. Possible that it would show burnt tracks on the board, but not always the case. Try these guys http://www.emwelec.co.uk or you can phone them on 01159652118, tell them Andy Stuart sent you and ask for Lee or Tony. They are normally pretty good at diagnosing the fault if you tell them which lights are flashing and will also be able to supply an exchange if needs be.
Hope this helps,

Andystu

Re: Hotpoint wf321

Andystu wrote: They are normally pretty good at diagnosing the fault if you tell them which lights are flashing

Of course you could always read the Known Error Codes thread to find out what the Error Code might be. 😉

Always best to give the lights by number from top to bottom or right to left.

1+3+4 is a pump drain fault. Are you getting power down to the pump, if not then it is likely that the pump burn out has taken out the PCB. A visual check will normally show signs of damage. This machine has a single phase motor so no large heatsink on the PCB.

Jim.