Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Miele G 638 plus diswasher
- This topic has 7 replies, 3 voices, and was last updated 15 years, 12 months ago by
Micky 32.
-
AuthorPosts
-
April 13, 2010 at 10:59 pm #53952
Micky 32
ParticipantThe machine fills, not the best pressure but ok. When it fills it starts up. You then hear the soapbox and after a minute or so it stops with the inlet/drain light flashing. It’s definately not a drain problem as it empties perfectly. My main suspect is the flow sensor, however the fact it starts up kinda puzzles me because i thought if the machine thought there wasn’t enough water would it start washing? Anyone else come across this fault?
April 13, 2010 at 11:18 pm #317850gegsy
ParticipantRe: Miele G 638 plus diswasher
IIRC try checking the recirc pump assembly and the little pressure switch attached to it for blockages 😀
Greg
April 15, 2010 at 10:56 am #317851Micky 32
ParticipantRe: Miele G 638 plus diswasher
Well Gegsy you were in the right area anyway 😆 . Checked but no blockages, very clean. However when i blew into the pressure switch it won’t click..thanks for the reply.
April 15, 2010 at 8:05 pm #317852Seamy
ParticipantRe: Miele G 638 plus diswasher
Hows it going in Longford?
Would be a help if you could know which fault code it was as F06, F07 & F08 will all flash inlet/outlet led. Likely its a dodgy flowmeter, there was a problem with them not seating correctly & sticking.
April 15, 2010 at 8:54 pm #317853Micky 32
ParticipantRe: Miele G 638 plus diswasher
Are you from near Longford?? This machine doesn’t have a display and the inlet light flashes constantly. The pressure switch is definately faulty as it seems stuck and won’t click when you blow into it.
April 16, 2010 at 6:36 am #317854Seamy
ParticipantRe: Miele G 638 plus diswasher
Micky i’m from Fermanagh, pressure sw’ is likely just very hard to make click by blowing in to it.
Circulation pump motor may have a blockage on the impellor & it can’t get up required pressure to cause pressure sw’ to activate. Circulation pump is easilly split to check this.
I know it doesn’t have display but if you go into service mode you can check fault codes.
Common problems are flowmeters incorrectly seated or plastic paper restriction on circulation pump impellor.April 16, 2010 at 8:48 am #317855Micky 32
ParticipantRe: Miele G 638 plus diswasher
Not too familiar with this machine. How do you retrieve the fault code on this machine?
April 16, 2010 at 7:37 pm #317856Seamy
ParticipantRe: Miele G 638 plus diswasher
sent you a PM as theres no e-mail address listed
-
AuthorPosts
- You must be logged in to reply to this topic.
