Creda 47917

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Creda 47917

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 27, 2010 at 4:37 pm #54237
    ray.t
    Participant

    Been to this today, it wont heat.
    I removed lower inspection cover and checked the heater and stat that I could see, both are ok.
    I then removed the door trim to check wires etc and there is a stat next to the dispenser that is O/C.
    Would it be a good idea to change both stats on this model or can I just change the one that has gone?
    Thanks
    Ray

    April 27, 2010 at 5:05 pm #318937
    Martin
    Participant

    Re: Creda 47917

    ray.t wrote:I then removed the door trim to check wires etc and there is a stat next to the dispenser that is O/C.

    I’m not familiar with this dishwasher as to the exact function of the stat in the door but suspect it is an overheat protection device? In which case just temporarily shorting it out would no doubt prove that heat has been re-established and that the door stat is faulty? 😕

    April 27, 2010 at 6:03 pm #318938
    ray.t
    Participant

    Re: Creda 47917

    Thanks Martin.
    I am not familiar with this model either.
    I did think to just short it out to test it but if the other stat is faulty would it not cause a new stat to go again?
    Cheers
    Ray

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.