- This topic has 3 replies, 3 voices, and was last updated 15 years, 11 months ago by
.
-
Posts
-
I have a heat pump to change on one of these tomorrow and wondering what the best way is to attack this one.
It looks similar to the Bosch with the solid base but has some differences.
has anyone had experiance of these?
Many thanks
geoff
Re: bosch SMS50E06 GB07
R/h panel off, Door skin off, plinth off. Cut off hose clip type thingy. Pull out heat pump 😀 Easy peasy. 40mins on a go slow, 15min when you have done a few 😉
Just be sure to make sure the new ‘hose clip type thingy’ 🙂 is positioned properly when the new one is fitted onto the hose .
Re: bosch SMS50E06 GB07
Hi
Sorry not posted back yesterday as still trying to catch up. Anyway tried removing rh side and module to cut the clip but could not get enough grip or room to cut the clip 😥
So on to the way I done it
Remove both side panels
Straighten tags at either side of tank at rear where is sits in base
Remove screw either side 1/3 way up tank at front attaching tank to hinge.
Remove 2 screws holding fill chamber and unclip. Will sit there on its own.
On the inside remove 4 screws holding sump, cap for air vent and fill cap/housing(large allan key) plus cap/nut for salt container.
With the door open and baskets removed tank will now tilt forward.
Hope I have remembered everything but did not remove plinth/door or disconnect door hinge springs. Just be careful of lower door sealGeoff
- You must be logged in to reply to this topic.