Hotpoint drum pulley, possible to change?

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint drum pulley, possible to change?

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • May 4, 2010 at 8:11 am #54360
    eastlmark
    Moderator

    Hotpoint WMD940G, is it possible to change the drum pulley without removing tub?

    May 4, 2010 at 9:03 am #319346
    SteveATY
    Participant

    Is it the normal 13mm hex centre bolt holding it all together? Is so there is probably room to ease the tub towards the front of the machine and get a long handled socket drive onto the bolt head.

    May 4, 2010 at 9:38 am #319347
    iadom
    Moderator

    Re: Hotpoint drum pulley, possible to change?

    I have done both the one with the hexagon and the one with the torx head with the drum in situ.

    Found it easier to remove the front panel which allowed the drum to be tilted forward for better access.

    Jim.

    May 4, 2010 at 5:53 pm #319348
    eastlmark
    Moderator

    Re: Hotpoint drum pulley, possible to change?

    thanks, its a bolt type, are these cracking in vast numbers then? this one only 13 months old.

    May 4, 2010 at 6:07 pm #319349
    iadom
    Moderator

    Re: Hotpoint drum pulley, possible to change?

    Not had that many, mainly just coming loose and knocking. :rolls:

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.