- This topic has 3 replies, 3 voices, and was last updated 15 years, 11 months ago by
.
-
Posts
-
eventually gave in and have hotpoint coming to this one.
everying tests out ok, but dryer just wont heat.
checked all terminals, current is flowing all around dryer, and no error codes or flashing.
just doesnt heat.
coil type element and thats been swapped out and also so has the thermal fuse. ntc varies, but didnt have a spare to try,
just cant fathom it so referred cust to h/p with presumed board failure.
but before he arrives thought id ask some advice…
Re: another hp wd440
gandh1 wrote: current is flowing all around dryer……
just doesnt heat.
I’ve never done this myself but your post makes me think it would be worth connecting an ammeter or clamp meter in line with dryer element.
My guess is there isn’t current flowing through the element for any length of time and the fault probably will be somewhere on the board.
If current was flowing your led screwdriver would only light up on one end of the element.
Mike.
- You must be logged in to reply to this topic.