Fisher & Paykel 608 .. won’t fill with water

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Fisher & Paykel 608 .. won’t fill with water

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • May 7, 2010 at 1:55 pm #54455
    fibe2207
    Participant

    My washer won’t fill with water .. was working fine then went to do a 2nd wash and nothing no water coming in and if I advance to spin cycle it is not working also. I have gone into the diagnostic mode and all the lights along the top are off.
    I had the control panel replaced 2 years ago. Please assist
    Thanks

    May 8, 2010 at 12:49 am #319671
    Penguin45
    Participant

    Re: Fisher & Paykel 608 .. won’t fill with water

    Resitance check of the water valves is the place to start, assuming that the machine lights up and programmes? That or the lid switch – particularly prone to sogginess and corrosion.

    Penguin45.

    May 8, 2010 at 5:54 am #319672
    fibe2207
    Participant

    Re: Fisher & Paykel 608 .. won’t fill with water

    Thanks for the quick reply.

    Yes the machine lights up and programs… will check the water valves. Will let you know of any developments.

    Cheers 🙂

    May 31, 2010 at 5:20 am #319673
    fibe2207
    Participant

    Re: Fisher & Paykel 608 .. won’t fill with water

    ok finally had a tech come look at my machine … turned out it was the lid switch. He just did a little bypass of it and all is working as intended.

    Thanks again for your assistance

    June 3, 2010 at 1:20 am #319674
    Penguin45
    Participant

    Re: Fisher & Paykel 608 .. won’t fill with water

    Get it replaced – the consequences of opening the lid during the spin cycle and the machne not stopping don’t bear thinking about. Safety issue – get it sorted.

    Penguin45.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.