elica cooker hood Model 150N2

Home › Forums › Public Support Forums › Help And Support › Cooker And Oven Forum › elica cooker hood Model 150N2

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • May 14, 2010 at 9:14 am #54607
    Batts
    Participant

    Had aloud bang from cooker hood-blown main fuse,Reset fuse trip now nothing works i.e lights or extcractor fan,1 bulb blown but surely fans should work without any lights.Suspect circuit board.Any ideas or where I can obtain spares Help please.

    May 14, 2010 at 12:18 pm #320318
    Washman
    Participant

    Re: elica cooker hood Model 150N2

    Hi

    Have you checked the fuse where the hood is plugged into.
    It should have a 3 or 5 amp fuse in plugtop or spur outlet depending on its set up.

    Washman

    May 16, 2010 at 1:36 pm #320319
    nomadPaul
    Participant

    Most extractor hoods are protected by a 3 or 5 amp fuse as Washman has suggested. A bulb blowing will sometimes cause these fuses to blow . You will need to find where the plug/socket is located and check this fuse. If it has gone , please make sure it is replaced by the SAME RATED FUSE. A lot of the time , the appliance plug and socket is situated behind the extractor chimney but as i don’t know your model , i can’t say it is 100{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}.

    June 26, 2010 at 10:32 am #320320
    ServEng
    Participant

    replace the pcb to the hood, you may find that the motor has also gone and has blown the pcb

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.