- This topic has 3 replies, 4 voices, and was last updated 15 years, 10 months ago by
.
-
Posts
-
Siemens Model SE24M851.
I’m getting a “Check Water” LED light on when I run a daily cycle.
The cycle starts off running fine, it then after 15mins or so it “hangs” in a cycle of drawing in water and pumping it straight out.
The clock stops counting down, remaining on the same cycle.
I’ve checked the inlet and outlet hoses, the filters and taken off the pump cover to make sure it’s running ok.
When I did all this and ran it again (leaving the room), it flooded the kitchen floor. As I said I’ve checked the oulet hose but it seems to be pumping water fine. Any suggestions?Re: Siemens “Check Water ” Error doesn’t fit.
I’ve got the same problem, some body advised me to replace the heater.
It worked for half a cycle and stopped again.
CAN YOU HELP???Re: Siemens “Check Water ” Error doesn’t fit.
I would say the first thing to check is the inlet water flow rate which is different to the pressure of course…you may have sufficient pressure but if a tap isn’t fully on, a hose is kinked (unlikely with a Siemens) or the inlet filter is partially blocked then it will overfill giving the symptoms you describe 😉
Failing that it sounds like a pcb fault but the BSH guys may know more…
HTH?If your model is as the one above and you’re having a problem in that when you first start the cycle all the appliance does is fill/drain/fill/drain and the tap light comes on then the most probable cause is a faulty flow rate meter ( impellor jug part no: 424099 ) Its a small white cylindrical component fitted inside the back left corner of the machine inline with the inlet hose.
It is a fairly common replacement part
- You must be logged in to reply to this topic.