- This topic has 11 replies, 7 voices, and was last updated 15 years, 10 months ago by
.
-
Posts
-
Due to the cost I have never had to do one of these before but have a three year old AEG with blown doorlock that has taken out the main PCB.
I can just about manage to manouver the PCB to take off the back cover and see the blown tracks.
Is there a knack to getting these things out completely and back in, or is it a struggle, hardly room for my tiny mits in there. 😥
Re: Zan/Lux main PCB change
cut all cable ties and plastic moulds on old pcb holding cables, and then pull upwards………its fiddly !!!!
Re: Zan/Lux W/D main PCB change
She has just rung back to give me the go ahead, don’t know if I should be pleased or not. 😉
It does look a real pig of a job. :rolls:
Jim.
Re: Zan/Lux main PCB change
A total PITA! Can’t believe how few Lux jobs you have up there that you haven’t had to do this till now.
Mike.Re: Zan/Lux main PCB change
It seems as though an epidemic is starting. 😀
Had five or six Lux group W/Dryers in past two days and had several with low insulation dryer elements in past few weeks.
Fitting a motor to one tomorrow, couple of brush jobs today on Zan machines, all grist to the mill. 8)
The locals are reluctant to pay for such expensive repairs as PCB’s normally but this one is a three year old integrated job so any replacement machine will be costly as well.
Jim.
Re: Zan/Lux main PCB change
Quick supplementary question re unconfigured boards. I have just had a quick look on TDS and can’t see any info on how to configure the PCB’s on these, am I missing something?
Model is a 914601218/01..ZJD12191
Re: Zan/Lux main PCB change
Hi.
You can only configure the board via a program called sidekick which is as far as I know only available to Serviceforce techs.
You can order a preconfigured board. Part number is: 973914601218014
Re: Zan/Lux main PCB change
Already got that on order and its £2 cheaper than the unconfigured board. :con:
I was just curious thats all. 8)
Jim.
Re: Zan/Lux main PCB change
careful Jim, 2 of these I did also needed the display board, no obvious damage but no lights or functions when turned on.
Re: Zan/Lux main PCB change
also had about 4 which have needed display board as previous poster has said but another 2 which also needed the analogic pressure switch as well!!!
cheers chris
- You must be logged in to reply to this topic.