- This topic has 6 replies, 4 voices, and was last updated 15 years, 9 months ago by
.
-
Posts
-
trying to get into freezer evap fan , what a pig
i removed 2 crews at top but evap unit will not budge ..does anyone know how to get into these things ..
cheers ally
Re: SEIMANS FF KG34NX90GB
cheers what the repair kit ??
f/f was running ok but fan blade sounded as though it was hiting something
ally
Th way the evaporator sits means that if it ices over , it practically glues itself to the lower cover and is a bugger to remove. If its given a real good defrosting then the cover will slide forward quite nicely. Just remember that there is a defrost heater on the cover and the connector will need to be unplugged from the rear wall connector prior to pulling the cover completely away .
If this is an older model , Pre-mid 2007 , then it may need the evaporator cover plate fitting and a new module . These were the 2 main components that needed replacing for the main modification that these applainces had early doors.
Re: SEIMANS FF KG34NX90GB
cheers .. went back today ..
as you said evap assy came forward no probs … uncliped defo wires
fan unit had slipped forward so i pushed it back dropped a bit of super glue on end of shaft , hopefully that will do it ..
advise cust may need mod kit if fault re-occurs ..
quite easy in the end … after defo
Re: SEIMANS FF KG34NX90GB
I know it’s an old thread but I’ve got one of these to look at. It’s an earlier 06 model. What’s the mod kit for? Any details please? This one sounds like a fan/over icing fault.
Thanks
If this is an older model , Pre-mid 2007 , then it may need the evaporator cover plate fitting and a new module These were the 2 main components that needed replacing for the main modification that these applainces had early doors.
- You must be logged in to reply to this topic.