Diplomat ADP8322

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Diplomat ADP8322

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • July 5, 2010 at 6:38 pm #55652
    allan73
    Participant

    Can anyone help me out with a fault code on this whirlpool built dishwasher, it runs for a short while then 1st light on left comes on and start light flashes constantly also it beeps constantly……… 😡
    Thanks in advance guys.

    July 6, 2010 at 6:48 am #324626
    allan73
    Participant

    Re: Diplomat ADP8322

    Ive read on here this could be a NTC fault is this correct ?

    July 6, 2010 at 9:00 am #324627
    electrofix
    Moderator

    Re: Diplomat ADP8322

    yes you are correct

    1 flash fault code look like a constant flashing light

    but check closely from memeory you can have anything up tp 15 flashes so watch it closely for at least 20

    i keep a spare ntc as a test had a few where it did not cure fault so had to assume board faulty

    hope this helps

    Dave

    July 6, 2010 at 10:03 am #324628
    allan73
    Participant

    Re: Diplomat ADP8322

    Thanks Dave,
    I watched for quite a long time & there was no pause but i will double check.

    July 7, 2010 at 10:42 am #324629
    allan73
    Participant

    Re: Diplomat ADP8322

    Can i test the NTC with a meter ? They’re not that cheap (whirlpool GRRR!)

    July 7, 2010 at 11:16 am #324630
    electrofix
    Moderator

    Re: Diplomat ADP8322

    just measered a new one at room temp (out of the machine )

    54K ohms

    hope this helps

    dave

    July 7, 2010 at 11:22 am #324631
    allan73
    Participant

    Re: Diplomat ADP8322

    Thanks again Dave 🙂

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.