- This topic has 7 replies, 3 voices, and was last updated 15 years, 9 months ago by
.
-
Posts
-
i have a beko wma510s machine,it fills,washes fine but needs to be manually moved on to rinse and spin.i have checked bushes and seem to be ok,any ideas will be much appreciated.
Re: beko wma510s not moving through wash sequence
May be a heater fault.
Remove mains plug, take off the back panel and test the heater with a megger or multimeter.
BTW, I think you may have actually checked the brushes, bushes are those green things in the garden. 😉
Re: beko wma510s not moving through wash sequence
yes i meant brushes(typing error).i have checked heater with multimeter,checks ok.machine heats up during cycle.
Re: beko wma510s not moving through wash sequence
Does it stop completely, just keep on tumbling from side to side or does it start to drain then stick?
Re: beko wma510s not moving through wash sequence
it washes then it pumps water out then drum turns but doesnt add water for rinse unless you stop machine and manually turn it to rinse.after rinse it then needs to be stopped and manually turned to spin.
Re: beko wma510s not moving through wash sequence
Not sure if that particular machine has a mechanical timer or a fully electronic PCB.
When you say it doesn’t add water, can you hear any water running but not actually filling into the drum?
It does sound like a timer fault TBH though.. 😥
Re: beko wma510s not moving through wash sequence
Maybe filter blocked & machine not emptying all water or appliance drain hose too far down waste pipe & is syphoning on next fill.
- You must be logged in to reply to this topic.