ISE 2

Home › Forums › Manufacturer/WP/Insurer Specific Forums › ISE Trade Support Forum › ISE 2

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • July 19, 2010 at 4:33 pm #55935
    robbra
    Participant

    Hi,
    got one that goes straight into spin. Presumably it’s the pcb like all the others.
    Am I correct?
    Thanks
    Rob
    Ser no. 00615851000350130045
    Two pcb listed on Whitegoods parts Which one?

    July 19, 2010 at 10:06 pm #325671
    iadom
    Moderator

    Re: ISE 2

    Moved you to trade spares. 😉

    Are you an ISE agent Rob, if so I will move this post to the ISE forum.

    THIS is the one you need.

    Jim.

    July 20, 2010 at 6:44 am #325672
    robbra
    Participant

    Re: ISE 2

    Thanks Jim,
    Thought that was the one.
    Yes I’m an agent but have never had authorisation for the ISE forum despite several requests.
    Rob

    July 20, 2010 at 9:56 am #325673
    iadom
    Moderator

    Re: ISE 2

    Moved to correct forum.

    Can someone ensure that Rob has access to the ISE forums please. 8)

    Jim.

    July 20, 2010 at 10:44 am #325674
    iadom
    Moderator

    Re: ISE 2

    Hope I haven’t stood on anyones toes or broken anything but I think I have been able to give you access to this forum Rob. 🙂

    July 23, 2010 at 12:39 pm #325675
    robbra
    Participant

    Re: ISE 2

    Thanks Jim,
    Had the new board and went fit it and nothing except the start light on. No fill, motor nothing but the door locks. The new board is beige but the old one was green, does this have any bearing on it?
    No fault showing with either the old or new boards. The connections are flimsy but I crimped them up.
    Not sure what to do next, could it be a faulty board?
    Any help most welcome.
    Rob

    July 23, 2010 at 3:03 pm #325676
    iadom
    Moderator

    Re: ISE 2

    Hmm, not something I have encountered, the board has been changed but the last one I did was a one for one swap.

    There are a couple of the connections that will fit on the wrong place on the PCB, got caught out once with that and the result was exactly as you describe. 😳

    I have changed four or five, all for spin on wash up to now.

    Jim.

    PS. There doesn’t appear to be a wiring diagram in the manual but there is a fault test routine.

    I do have a copy of a Vestel wiring diagram, its supposed to cover the ISE 2, I will send you a copy just in case.

    July 23, 2010 at 3:46 pm #325677
    robbra
    Participant

    Re: ISE 2

    I’ve downloaded the tech manual and your diagram so will go armed and can trace the wiring from that PCB photo. Very poor connections on the board so it may be something there. Thanks again.
    Rob

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.