- This topic has 3 replies, 2 voices, and was last updated 15 years, 8 months ago by
.
Viewing 4 posts - 1 through 4 (of 4 total)
-
Posts
-
have a weird fault. The water inlet for dryer never seems to have a neutral. I’ve tested for a good 15 mins, pump comes in and out but no neutral to the valve. Are the 2 cut outs at the front open or closed circuit. When I tested them (hot) the front was open circuit and the one behind closed. Is this correct? Any ideas??
Re: bosch wvt1260gb01 not condensing
yorkshireracer wrote:havAre the 2 cut outs at the front open or closed circuit.
What cut outs are you on about? 😕
Valve failure is common on these especially on the dryer. Just try sticking a new valve in. 💡
Re: bosch wvt1260gb01 not condensing
Allready has new valve. 2 stats/cutouts on front of heater box.
Viewing 4 posts - 1 through 4 (of 4 total)
- You must be logged in to reply to this topic.