- This topic has 9 replies, 4 voices, and was last updated 15 years, 7 months ago by
.
-
Posts
-
Now here’s one for all you Hotpoint experts 😉
WMA35, fitted a new door seal on Monday, checked and tested it all OK
First wash by customer worked ok, next wash select any programme and machine goes straight into rinse and spin only, no door closed light on but door locked ok.
This is where I come in again. Sure enough as customer says only does rinse and spin.
I put it through the test prog . and a component test all ok 😕Next I checked to see if the board was configured correctly, as it was. Still no wash. My immediate thought was that the board was corrupted so I attempted to re-configure the board with no success. I attempted this five times before it allowed me to re-configure:?
Put the maching on wash, now work fine.I had previously repaired the board after the wiring loom had “chafed” but that was a couple of years ago
Now I thought I new these buggers inside out but this one has completely stumped me 😳 Any ideas peeps?
Re: Hotpoint WMA35 Confused
Check for bad soulder or dry joints in the areas that you repaired before.
George
Re: Hotpoint WMA35 Confused
Allsorts wrote:Check for bad soulder or dry joints in the areas that you repaired before.
GeorgeDone every inch of the PCB with a magnifying glass, only PCB track damage previously, soldered up beautifully if I do say so myself :rolls: 😆
Re: Hotpoint WMA35 Confused
Time to stuff the PCB into a jiffy bag and get Tony to suss it for you Mal. 💡
Re: Hotpoint WMA35 Confused
Martin wrote:Time to stuff the PCB into a jiffy bag and get Tony to suss it for you Mal. 💡
No need martin, the machines working perfectly now, I am just confused why it took several attempts to programme the sod
Re: Hotpoint WMA35 Confused
maltheviking wrote:No need martin, the machines working perfectly now, I am just confused why it took several attempts to programme the sod
“The sod” you refer to is feminine don’t forget and it takes time and patience to get a female under control as well you know. 8)
Re: Hotpoint WMA35 Confused
Martin wrote:
maltheviking wrote:
No need martin, the machines working perfectly now, I am just confused why it took several attempts to programme the sod“The sod” you refer to is feminine it takes time and patience to get a female under control as well you know. 8)
Do I actually believe that you have cracked the question that men have looking for from the beginning of time, if so :worthy:Re: Hotpoint WMA35 Confused
If that’s the case i need lessons of martin.
Every time i even get close to trying to understanding my other half let alone controlling her she does not just move the goal posts she changes the bl{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}dy game completely!!!!
All hale martin :worthy: :worthy:Phil
Re: Hotpoint WMA35 Confused
Well there you go, you live and learn eh Mal? 😉
You did mention that you “re-configured the board” but clearly that was a typo error you made and should have read “re-configured the bird”. It’s all down to knowing which buttons to press on them that’s all…. 8)
- You must be logged in to reply to this topic.