Few12 program module help

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Few12 program module help

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Posts
  • August 19, 2010 at 10:18 am #56641
    A1_Domestics
    Participant

    Fitted a board from what I thought was the same model machine and now It doesn’t get any fast spin.

    Motor and pump test ok, so the only option I’m left with is to reprogram the board. We’ve only got the config codes for the wma’s so would appreciate any help on this.

    August 19, 2010 at 10:21 am #328245
    electrofix
    Moderator

    Re: Few12 program module help

    ring tony at emw am sure they can test and reprogramme

    Dave

    August 19, 2010 at 11:27 am #328246
    A1_Domestics
    Participant

    Re: Few12 program module help

    I’ve used EMW plenty of times and they do a great job but I’m sure if it’s not a simple reprogram I will be ordering a new pcb.

    August 19, 2010 at 5:17 pm #328247
    iadom
    Moderator

    Re: Few12 program module help

    Is it a screwed or welded drum?

    August 19, 2010 at 5:19 pm #328248
    A1_Domestics
    Participant

    Re: Few12 program module help

    Screwed. I hope I ain’t though!

    August 19, 2010 at 6:16 pm #328249
    iadom
    Moderator

    Re: Few12 program module help

    Check your inbox. 😉

    Jim.

    August 20, 2010 at 10:51 am #328250
    A1_Domestics
    Participant

    Re: Few12 program module help

    fixed!

    Jim, this is for you: http://amiawesome.com/

    August 20, 2010 at 11:28 am #328251
    electrofix
    Moderator

    Re: Few12 program module help

    And the problem was ………..?

    Dave

    August 20, 2010 at 12:45 pm #328252
    A1_Domestics
    Participant

    Re: Few12 program module help

    For future reference, the wires on the board going to the pressure switch and the heating element were crossed.

    in the past this had the effect of not releasing the door lock, but on FEW machines causes no fast spin. Luckily, the pcb has not been affected.

    August 20, 2010 at 3:57 pm #328253
    iadom
    Moderator

    Re: Few12 program module help

    A1_Domestics wrote:

    Jim, this is for you: http://amiawesome.com/

    😳 8)

  • Author
    Posts
Viewing 10 posts - 1 through 10 (of 10 total)
  • You must be logged in to reply to this topic.