bosch WFO2467 GB/17 fill and spin fault

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › bosch WFO2467 GB/17 fill and spin fault

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 1, 2010 at 1:04 pm #56930
    electrofix
    Moderator

    Bosch auto WFO2467 GB /17

    select spin
    machine starts pumps timer starts to count down and drum revolves. after about a minute timer goes to 1 minute

    select rinse ans spin
    macine fills and turns normally ( have not run prog to end )

    select wash cotton 40 degrees
    machine starts to fill then stops and starts seems to be more eratic when motor starts but not sure. motor reverses ok

    tried disconnecting earth on heater and heater wires but no diff

    any ideas bosch geeks out there

    Dave

    September 3, 2010 at 3:23 pm #329306
    electrofix
    Moderator

    Re: bosch WFO2467 GB/17 fill and spin fault

    any thoughts ?

    September 3, 2010 at 4:12 pm #329307
    Allsorts
    Participant

    Re: bosch WFO2467 GB/17 fill and spin fault

    Initial thoughts: Presuming that you have checked the motor brushes and they are fine, check to see if the motor comm is clogged with carbon .. and check the tacho

    September 3, 2010 at 5:13 pm #329308
    Martin
    Participant

    Re: bosch WFO2467 GB/17 fill and spin fault

    electrofix wrote:tried disconnecting earth on heater and heater wires but no diff

    Seems to me that the problem IS the heater. But I’m thinking that you must have meggered it anyway? Hmmmm? My reasoning being that if you disconnect the heater leads the machine would throw a wobbly anyway! Have you checked truly the heater? 😕

    September 4, 2010 at 11:34 am #329309
    electrofix
    Moderator

    Re: bosch WFO2467 GB/17 fill and spin fault

    @ martin

    no have not megged it but will do and see what i get

    thanks

    Dave

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.