- This topic has 3 replies, 3 voices, and was last updated 15 years, 7 months ago by
.
-
Posts
-
I have a customer with a F1 fault showing on her ISE10.
According to the manual this is an overfill. The machine is about a 3 weeks old. Is there anything stupid the customer could have done to cause this or am I going to have to go out.
Re: ISE10 Fault F1
If the lights around the start button are all lit then yes, it’s an overfill.
If it’s only two or three (can’t recall exactly) it’s the door not closed or registered as closed.
Overfill you can get with that overfoaming thing going on. Also sump ecoball jammed can do it as well.
Other than that I can’t think on anything obvious other than the usual suspects.
K.
Re: ISE10 Fault F1
Went to this today and the display was blank and water more than halfway up the door.
Tried to drain but just got a buzzing noise. Drained through syphon hose and removed kirby grip from pump impellor.On quizzing the customer found out the machine had not finished previous cycle so she attempted to start it again and it filled then came up with F1 which is correct as it had overfilled. But why did it attempt to fill again when it was already full?
Anyway it is all working now, so in future if you get F1 fault check the pump.
- You must be logged in to reply to this topic.