- This topic has 10 replies, 5 voices, and was last updated 15 years, 7 months ago by
.
-
Posts
-
On spin, motor runs at its gradual increasing speeds fine but on final fastest speed it runs & runs. Have to move dial on manually to stop?
Re: beko wm1512 motor run-on
I would meg the motor connector pins and check the tacho and check brushes on motor to rule them out first and wiring on connector block.I know the modules seem to act up on these from what i have found out but i would rule out the easiest first.
I have a wma1512w to look at tomorrow not taking powder from middle dispenser (main wash) but takes it ok from pre wash compartment already looked at it but could not find anything wrong ,no blockages and valves all working … :rolls:
Re: beko wm1512 motor run-on
if you want tech info let me know full model numbers and an email address
Dave
Re: beko wm1512 motor run-on
Had an ISE5 mk1 doing the same thing (would not stop spinning). Found low insulation on motor, new motor sorted it.
Mike.Re: beko wm1512 motor run-on
electrofix wrote:if you want tech info let me know full model numbers and an email address
Dave
Beko WM1512S. 66martin@sky.com-ThanksRe: beko wm1512 motor run-on
Motors fine,boards fine, I’am thinking its the timer. Don’t want to get new or recon timer if its something else-anyone had this problem?
- You must be logged in to reply to this topic.