Zanussi ZSF 2450 leaking and won’t switch off

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Zanussi ZSF 2450 leaking and won’t switch off

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 12, 2010 at 8:54 am #57185
    roehampton
    Participant

    Hello all,

    My tabletop Zanussi cut out last night, and tripped the RCD switch. When I reset the RCD switch and switched it on, it resumed pumping and wouldn’t switch off until I pulled the plug. It was also leaking from underneath (NOT the fill hose).

    This morning I reset it and started it on a simple rinse cycle. It filled normally, but then started leaking from underneath (seemingly front lefthand corner), and again wouldn’t switch it off until I pulled the plug. With the plug out, I tilted it back a little to look underneath and lots of water ran out of the back of it.

    Any ideas? It is only 13 months old. I would really appreciate any help as I do rely on this DW quite a bit, it’s on once a day on average and has been problem-free up to now.

    January 10, 2014 at 6:51 pm #330174
    Swilter
    Participant

    Re: Zanussi ZSF 2450 leaking and won’t switch off

    Hi, did you find a solution to this?
    I have exactly the same issue with the same model.

    Thanks

    January 10, 2014 at 9:20 pm #330175
    Martin
    Participant

    Re: Zanussi ZSF 2450 leaking and won’t switch off

    Swilter wrote:Hi, did you find a solution to this?
    I have exactly the same issue with the same model.

    The only sure way in locating the leaks is by getting hands on. Power unplugged, lay appliance on its back (only) and remove the bottom panel. Signs of water leakage should be apparent once that panel is removed.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.