- This topic has 2 replies, 3 voices, and was last updated 15 years, 6 months ago by
.
-
Posts
-
Hi Gents
esl6310 911939233 need help as there was no heat on machine tested heater and cable all ok what happens is when 30 min wash asked for the machine empties then stop for 2 mins or so then fills and washes dispensor opens no L or N to heater live comes from P/Switch neutral from board suspect P/Switch fault shorted P/Switch to send live to heater but still no N to element FITTED NEW MODULE filled up after drianing no 2 min delay washed dispensor opened but no heat agian am i missing somthing readings on thermistor ok
cheers alroRe: Electrolux dishwasher not heating
Check the module/programmer, take it out and check the connections to the big black relay on the board! probably blown. Repair , replace relay or replace borad!
Jazz!
Re: Electrolux dishwasher not heating
if you have replaced board and shorted pressure switch ( for test puposes) then can only be an ntc prob try measuring NTC from board
connections H1 and H3 accoring to manual 4850 ohm at 25 degrees
you could disconnect NTC and short out with 5k resistor and see if heater kick in
have got tech info if you want it but cnat thinks of anything else you have not checked or changed
Dave
- You must be logged in to reply to this topic.