- This topic has 5 replies, 2 voices, and was last updated 15 years, 6 months ago by
.
-
Posts
-
Re: Hoover HNV380
Allsorts wrote:Does anyone have a service manual for this model please.
They don’t exactly do one George I afraid…there is a ‘Test’ manual for it though…is that of any use to you?…What are you wanting to know anyway?
Re: Hoover HNV380
Test Manual would be great Martin. 🙂
The machine I have here tests ok on Heater, Cut-outs, motor, Door catch .. Run it on cold and it will run until end of program, but, run it on any heat program and it will run for 4-5 seconds then stop… Power remains at the Cut-outs and switches. It is as if a board supply part is shutting down.. I would say proberly heater relay but can’t be sure without testing it.
George
Re: Hoover HNV380
Allsorts wrote:Test Manual would be great Martin. 🙂
OK…email me your email address (not on your website for some reason?) and I’ll shift it your way.:D
Re: Hoover HNV380
Ecellent Martin thankyou… It seemed a bit like double-dutch to understand but then I assume it is a translation.
I have now ran a test but the test procedure came up with no error codes.. hence I presume it thinks that there are none.
Luckily I have another in the shop that has just been finished, so I ran the same test on that one to see if there were any differences at all… All I noticed is that during the original run on the drum, just before the error codes are produced, the drum stopped and did a reverse tumble, however, on the machine with the problem it did not. Therefore I can only summise that the problem is that there is no reverse tumble and that alone is causing the machine to halt.
Do you have an idea of which relay is which on the control board?
George
- You must be logged in to reply to this topic.