Hoover HP6 120M won’t start.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover HP6 120M won’t start.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 21, 2010 at 3:45 pm #58195
    iadom
    Moderator

    I fitted new motor brushes to this machine a couple of weeks ago, all seemed well at the time.

    Now it won’t start any programme, set it to wash, rinse or spin and the drain pump kicks in for a split second then cuts out. If you switch it on and off it will keep doing this. ❓

    This pump has a built in overload so tried a different pump but that did the same.

    Also tried a selector switch to no avail.

    Any pointers or is my guess of a PCB problem the likeliest scenario?

    Jim.

    October 22, 2010 at 7:27 am #333688
    Martin
    Participant

    Re: Hoover HP6 120M won’t start.

    iadom wrote:Any pointers or is my guess of a PCB problem the likeliest scenario?

    I would tend to agree. Whip it out and give the surface components a viual check especially the triacs.:wink:

    I’ve emailed you some light reading.:D

    October 22, 2010 at 9:01 am #333689
    iadom
    Moderator

    Re: Hoover HP6 120M won’t start.

    Thanks Martin. 8)

    October 22, 2010 at 9:29 am #333690
    cornwell40
    Participant

    Re: Hoover HP6 120M won’t start.

    Martin wrote

    Whip it out

    Matron….he’s at it again 😉

    TC

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.