Hotpoint WF541

This topic has 3 replies, 2 voices, and was last updated 15 years, 5 months ago by jackster.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
October 25, 2010 at 4:36 pm #58282

jackster
Participant

Hi all, I have got this appliance flashing a no drain fault, no blockages anywere and pump doesnt run, I changed the pump for one on van but still the same? Pressure switch clear and ok, pump is getting 180v to it so im assuming board is faulty? I have checked connections etc.

October 25, 2010 at 6:11 pm #333982

maltheviking
Participant

Re: Hotpoint WF541

Pumps are 240v so your 180v supply is at question

October 25, 2010 at 6:38 pm #333983

jackster
Participant

Re: Hotpoint WF541

So is that a board fault? I have got the 180V to the pump and 240 to board?

October 25, 2010 at 7:14 pm #333984

maltheviking
Participant

Re: Hotpoint WF541

Boards on these are a bit of a PITA Send it off to EMW for test/repair if you don’t wan’t to buy a board.
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.