hoover dyn10146p washer

Re: hoover dyn10146p washer

ERROR CODE MOST PROBABLE REASONS FOR THE ERROR CODE:
E:01 Defective Door Safety Lock Device and/or Triac on Power Module and/or
Wiring.
E:02
The Water Fill Phase was not completed within the designed limit time.
Defective Solenoid Valve, Pressostat, Water Fill Hose, Low Water Pressure in
the network and/or Wiring.
E:03 The Water Drain Phase was not completed within the designed limit time.
Clogged Filter, Drain Pump, Drain Hose, Wall Discharge and/or Wiring.
E:04 Several (3) interventions by the Anti-flood Safety Contact of Pressostat.
Solenoid Valve blocked opened, defective Pressostat and/or Wiring.
E:05 NTC Temperature Reading Probe opened or shorted and/or Wiring.
E:06 Counter of Interventions by the Anti-unbalancement System (MEM readable
only).
E:07 Defective Door Safety Lock Device (blocked closed) and/or Wiring.
E:08 Defective Tachometric Dynamo (opened or shorted) and/or Wiring.
E:09 Defective “Cuore” Power Module (damaged Motor’s TRIAC) and/or Wiring.
E:11 Open Circuit on NTC Probe for Drying and/or Wiring.
E:12 Open Circuit on Drying Module and/or Drying Heater and/or Wiring.
E:13 Defective “Cuore” Power Module and/or Wiring.
E:14 Missing Water Heating: defective NTC Probe and/or defective Water Heating
Element and/or Wiring.
E:15 Not Programmed “Cuore” Power Module.
E:16 Water Heating Element is short circuited or defective electrical insulation.
E:17 Wrong signal from Tachometric Dynamo.
E:18 Defective “Cuore” Power Module – Wiring – Wrong Network Frequency (with
Knob Programs Selector).
E:18 Power-ON Times Counter (with Soft Touch Programs Selector – see Technical
Note 015lb09).
Best regards.

hsd to do a quick copy n paste got to go out

hth phil