AEG Dishwasher 545 ENr 606 281 387

Home Forums Trade Technical & Spare Parts Forums Trade Technical Enquiries AEG Dishwasher 545 ENr 606 281 387

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #5879
    laurenceuk
    Participant

    Hi Folks.

    Seems to have a pressure chamber problem. Pressure switch not resetting after emptying, pull hose off pressure switch and you can hear it reset. Is it blockages in the chanels of the chamber? Because it is white plastic I cannot see internally. If so any ideas how to clean out or is it a new chamber and sump manifold assy.

    Thanks

    Laurence

    #114329
    eastlmark
    Moderator

    Re: AEG Dishwasher 545 ENr 606 281 387

    Assuming its not had one before (you can tell by the rubber tube and 2 jubilee clips connecting it to the tub) you have to cut the old one off (Hacksaw!) to replace it. It comes as a kit with the afformentioned rubber tube and clips. Its not tricky to change but you need to take the side and base off and make sure the door spring clears the chamber before putting the side back on (open and shut the door to test) and make sure no water leaks into the drain pump plug as it will go bang if it does. Up to a couple of years ago we were changing these often 2 times a day everyday and then doing it again 18 months-2 years later, it was a good earner, sadly now done rarely.
    Sorry, no part number to hand, and I am away tommorrow, I am sure someone else will post it before then, about £30= vat.

    #114330
    laurenceuk
    Participant

    Re: AEG Dishwasher 545 ENr 606 281 387

    Thanks Mark?

    I have a week whilst the customer is on hols so if no one else posts it is much appreciated that you will be able to supply the part number.

    Laurence 😀

    #114331
    APG
    Participant

    Re: AEG Dishwasher 545 ENr 606 281 387

    Hi Laurenceuk

    Part number required is 899646403223/5 and retails at £31.56 + VAT

    apg

    #114332
    laurenceuk
    Participant

    Re: AEG Dishwasher 545 ENr 606 281 387

    Thanks apg,

    Very much appreciated.

    Laurence

Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.