- This topic has 4 replies, 3 voices, and was last updated 15 years, 4 months ago by
.
-
Posts
-
can anyone give me any advice on bearing change for this machine. have not seen m/c yet.i know it is the better job to change spider at the same time and most of you do, but is it allways nec. cost of spider has been the reason for ber on some jobs lately(mainly zan)paul
Re: hotpoint few 10p advice please
If you have not seen it yet then I suggest you go and take a look first,
Some FEW10’s have a sealed drum. 😉
Also the ones with the screwed drums can have either 30mm or 35mm bearings and shaft.
Both types of bearing kits are available but you cannot get a 30mm spider only the 35mm one.
Ring the customer and ask them if there is a black pump filter behind the lower front plinth. If there is then it has the sealed outer drum in it.
Jim.
Re: hotpoint few 10p advice please
thanks for the info jim, it belongs to an elderly couple who thankfully are not too far away from me.i will pop in on mon and have a quick look at it.paul
Re: hotpoint few 10p advice please
If it has a screwed drum then often a plastic drum pulley will point to a 30mm bearing machine but not always. 😉
The top concrete weight is a better guide, if you are familiar with the normal, early WMA top weight then the 30mm model has a much thicker weight. often much smoother as well.
Jim.
NB. When fitting bearings or drum rear half to standard WMA’s I would guess that I fit a drum spider on only 33{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of them.
- You must be logged in to reply to this topic.