Siemens dishwasher not finishing

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Siemens dishwasher not finishing

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 18, 2010 at 10:12 pm #58983
    simtoms
    Participant

    Been back to a Siemens SE25A090GB17 which goes through the cycle fine but when supposedly finished with display on ‘0’, still runs the circ motor although sump is drained (small amount of water still running out of spray arms). Been through pressure system, and now a bit stuck…
    Anyone remember having this before please? Thanks. Simon.

    November 19, 2010 at 9:01 am #336375
    Martin
    Participant

    Re: Siemens dishwasher not finishing

    Whip the module out and take a look at the surface components.:wink:

    My guess is that a triac has blown or some such? If so you’ll then need to locate the component that caused it to blow. 💡

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.