Zanussi ZDT6252 is this just a valve ?

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi ZDT6252 is this just a valve ?

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 16, 2010 at 7:37 pm #59629
    allan73
    Participant

    When you set this on a programme pump runs then there is buzzing I’m guessing from the valve then intermittent bursts of pump. All the time no water is filling. I’ve checked the water supply and it seems fine, no kinks in fill hose etc.
    This may be an obvious fault but I’m a novice on dishwashers and just looking for some confirmation as I havent been able to get the M/c out.

    Thanks Allan.

    December 17, 2010 at 10:10 am #338956
    Seamy
    Participant

    Re: Zanussi ZDT6252 is this just a valve ?

    buzzing could be the circulation pump motor sticking, on startup it runs pump, then fills, then circulate

    December 17, 2010 at 10:49 am #338957
    allan73
    Participant

    Re: Zanussi ZDT6252 is this just a valve ?

    Thanks Seamy, M/c does not fill so I thought more likely just a valve.
    I’ve been told it’s got some sort of anti flood protection buit into the valve if that has any bearing on it ?

    December 18, 2010 at 10:13 pm #338958
    mirmay
    Participant

    Re: Zanussi ZDT6252 is this just a valve ?

    Diaphragm on inlet valve, if it’s owt like the old tricity bendix/ zanu m/c’s Try (gently) twatting it with a screwdriver handle. More correctly, remove air pipe from diaphragm and establish why it’s activated in the first place (may not be a reason.)

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.