- This topic has 4 replies, 4 voices, and was last updated 15 years, 3 months ago by
.
-
Posts
-
Hi,
Push button unit (5 button-type) blown solder tracks on terminal connection 19 (from door lock), terminal connection 18 also seems charred (from power electronic). Fitted replacement and it popped again, same place. Anyone come across this before? Can tracking be resoldered? Is door lock causing this?
Thanks
Conor!Re: Miele WS5426 push button unit keeps blowing
conormccleane wrote: Anyone come across this before? Can tracking be resoldered? Is door lock causing this?
Thanks
Conor!1. I haven’t 2. Probably, but could be fiddly. 3. Quite likely. Suggest remove it (the lock) dismantle and examine. Better remove and examine electronic as well, as that may be damaged. Sounds like it could end up seriously expensive. Definitely don’t buy more parts till you’re sure you’ve understood the problem.
Mike.Re: Miele WS5426 push button unit keeps blowing
hole in top of door seal is known to blow the switch bank assy , doesnt have to be a very big hole either !
Re: Miele WS5426 push button unit keeps blowing
Door lock faulty – replaced with recovered unit – also had a spare pushbutton unit – sorted.
Re: Miele WS5426 push button unit keeps blowing
sounds like door lock but i did catch wire to door lock once when doing up the 3 bolts around door seal. this blew track on board so i soldered wire straight to it and worked fine. if you havent changed lock i would do that first and inspect loom when you change it
- You must be logged in to reply to this topic.