Bosch WAA24171GB/12

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch WAA24171GB/12

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • January 5, 2011 at 3:12 pm #59957
    Johnokent
    Participant

    Went to look at this today, machine has RINSE led flashing about 1 sec interval. Cannot clear this at all, Scanned through known fault codes can’t find faults code on this(is there one?) Apart from flashing LED machine is dead, door interlock not locking. any ideas. Interlock fault? Could’nt go to far today because of time and machine built into unit with drier on top. Dont you just love them!

    Thought I’d run this past you clever lads out there

    Thanks

    John

    January 5, 2011 at 3:58 pm #340210
    Johnokent
    Participant

    Re: Bosch WAA24171GB/12

    Just had second thought on this, do these machines have flood switch? door gasket is not to good. As I said I couldnt get it out today so not able to look.

    Thanks

    John

    January 5, 2011 at 4:50 pm #340211
    Martin
    Participant

    Re: Bosch WAA24171GB/12

    If it is JUST the RINSE led that flashes?….then it’s a Motor fault.

    HTH? 😀

    January 6, 2011 at 8:33 am #340212
    Johnokent
    Participant

    Re: Bosch WAA24171GB/12

    Thanks, yes just the Rinse light flashing. No matter how program is selected, it would allow me to cancel out. door won’t lock nor does waste pump run.
    Not sure how old machine is but does get a lot of use so are we just looking at worn brushes? or module. I’ll go back there today and extract machine from its hidey hole. Let you know how I get on

    regards,

    John

    January 6, 2011 at 8:46 am #340213
    Martin
    Participant

    Re: Bosch WAA24171GB/12

    Probably just the brushes, hopefully. The date code is the 4 digit FD number (FD????) by the way (e.g FD8806 = June 2008)…HTH? 😀

    January 11, 2011 at 4:56 pm #340214
    Johnokent
    Participant

    Re: Bosch WAA24171GB/12

    Hi, just for info changed brushes, existing were well worn but not u/s. Flashing rinse light still showing. Checked motor and PCB over no obvious damage, but noted, no power to door interlock. Any other ideas? Looking more like board fault? from date code machine is only 2 years old but it in a busy pub restaurant so does get a LOT! of use.

    Thanks

    John.

    January 11, 2011 at 5:11 pm #340215
    Martin
    Participant

    Re: Bosch WAA24171GB/12

    Try resetting the machine. 💡

    Hold the start button down for about 3secs and at the same time turn the dial one click to the 1 o’clock position. Release the start switch and put dial back to the off position. Hopefully that will reset it?

    What was the megger reading on the motor by the way? ‘Cos sure as hell the fault lies there somewhere. 😉

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.