indesit w133s won’t start program

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › indesit w133s won’t start program

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 4, 2011 at 7:00 pm #60790
    brimble
    Participant

    hi folks,

    i have a problem with my washing m/c. when starting a program i always turn the machine on at the on/off button, then turn the program wheel to a black dot and wait for the 3 rapid rad LED flashes, then i turn the program knob to the desired program and it used to do the trick. now it simply gives 3 repid flashes when i try to start a program and then the light comes on and stays on but the program does not start and nothing happens whatsoever.
    does any body have any ideas, or does the machine require binning? after all, it is a few years old now and had 2 new seals and a new drum in that time so it’s almost like triggers brush 🙂 but is it time to cut my losses.

    cheers folks,
    bryn

    February 4, 2011 at 7:17 pm #343650
    iadom
    Moderator

    Re: indesit w133s won’t start program

    brimble wrote: so it’s almost like triggers brush

    Maybe not trigger’s but checking the motor brushes would be a good place to start.

    Be sure to remove the mains plug before you go inside. 😉

    February 4, 2011 at 8:09 pm #343651
    brimble
    Participant

    Re: indesit w133s won’t start program

    thanks for the fast reply iadom, i have just been to check the brushes and they do seem to be quite worn but are still making contact witht the motor commutator. what does this sound like to you?

    cheers,
    bryn

    February 4, 2011 at 10:36 pm #343652
    iadom
    Moderator

    Re: indesit w133s won’t start program

    Brushes are cheap enough to try before you decide to bin it. 😉

    The ends of the brushes should be very shiny, if they look rough and pitted they are shot.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.