- This topic has 7 replies, 5 voices, and was last updated 15 years, 1 month ago by
.
-
Posts
-
i went to this washer today , s/n 309041046 91268710002, constantly taking in water , the solenoids are always energised even when the m/c is turned off , select a program and start and it pumps out and fills at the same time , and when the pump stops it just keeps filling and filling , i saw the red led flash 2 times slowly and then 3 times quickly and then it just keeps flashing slowly just when it is turned on no program selected , i checked brushes and armature cleaned them and the ntc and heater element 63.4 ohms from element and 3.4 million ohms from ntc anyone have any diagnostic info thanks
Re: indesit w123 uk bg
Had same problem with a Bush washing machine this week.
can only be pcb i would think
EMW should sort you out with a refurbished board or slightly slower you can send your board in for test and repair.
Re: indesit w123 uk bg
they should have them in stock and will send you one for about £40
and if its not that you send it back for a handling charge of about £6,
if it works you send them the old board.
call them on 01159652118
its definately the pcb.Re: indesit w123 uk bg
Trace the supply wires to the valve that is letting water in… See if it is being energised by a short.
Re: indesit w123 uk bg
they’re both energised , the wires are heading back down the r/h front past the door interlock, i see the control board down there near the base !
Re: indesit w123 uk bg
Filling all the time regardless of programme is a common PCB fault on this rubbish.
Jim.
- You must be logged in to reply to this topic.