Hotpoint CTD85 NTC or not NTC

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint CTD85 NTC or not NTC

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 19, 2011 at 5:11 pm #61175
    allan73
    Participant

    This beast is coming up F-13 after a few seconds, ntc is not open but reads 333 ohms at room temp (ohms not kohms). Am I correct in thinking the reading should be alot higher ? Also the display constantly flickers but I think that’s a side issue.

    Allan.

    February 19, 2011 at 7:29 pm #345141
    iadom
    Moderator

    Re: Hotpoint CTD85 NTC or not NTC

    • Check security of module connector J4;
    • Test from J4 connector pins 1 and 2 (approximately 500
    Kohms);

    February 19, 2011 at 7:37 pm #345142
    allan73
    Participant

    Re: Hotpoint CTD85 NTC or not NTC

    Thanks Jim, I’m only getting 333ohms across the rear ntc so I guess it’s shot ❗

    Allan.

    February 19, 2011 at 9:08 pm #345143
    iadom
    Moderator

    Re: Hotpoint CTD85 NTC or not NTC

    Info is actually, HERE 😉

    Jim.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.