- This topic has 5 replies, 3 voices, and was last updated 15 years, 1 month ago by
.
-
Posts
-
hi,went to this t/dryer today not heating fault.replaced rear stats which were o/c,but the fault code lights are still saying open rear ntc ,any suggestions regards tedd
Re: hotpoint ctd40
tedd wrote:hi,went to this t/dryer today not heating fault.replaced rear stats which were o/c,
Are you sure? One of these is an NTC and will appear O/C with a simple continuity test.
Did you change the NTC for an ordinary stat?
There are also two different NTC/stat kits, one TOD and one ELTH, they are not interchangable.
Re: hotpoint ctd40
Check connector J4 on main PCB, check NTC it should be about 500 Kilohms at room temp (20 deg) when checked at the NTC with the wires disconnected, Check for faulty wiring between J4 & the NTC, If NTC shows out of spec replace with correct type NTC, as Jim said 2 types available & they are definately not interchangeable, if all of the above checks out Replace main control PCB.
Re: hotpoint ctd40
hi,thanks for the replies,the white spot was o/c and they come in a kit part nocoo116598 or 1703200 is this right one regards tedd
Re: hotpoint ctd40
Completely wrong part. Its possible the original ‘one shot’ was faulty but the NTC would have been OK, usually due to clogged condensor.
You have fitted two thermostats when you should have fitted a one shot stat and an NTC kit.
Correct numbers are C00208298 for the one with the white NTC, and C00208299 for the one with the black NTC.
That is why you are now getting the NTC faulty error message.
- You must be logged in to reply to this topic.