Hotpoint WDL520P

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WDL520P

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 27, 2011 at 6:49 pm #61340
    Specialist01269
    Participant

    Hi all: need service info for this “Wonderful” machine if possible.


    Thanks: Andy

    February 27, 2011 at 7:10 pm #345772
    iadom
    Moderator

    Re: Hotpoint WDL520P

    Its possible, 😀

    Jim.

    February 27, 2011 at 7:21 pm #345773
    Specialist01269
    Participant

    Re: Hotpoint WDL520P

    Hi Jim: Cheers for the reply mate, apparently this machine has been looked at by someone else for a no heat fault but now it’s Intermittently going Dead with some lights flashing but she can’t remeber which.
    Second 1 of these i’ve had in the last week after the same bloke, last 1 was no dryer heat so he replaced the wash element as it apparently does both. Go figure. Luckily all that 1 took was a replacement Dry element & Re seat a couple of connectors properly.
    Anyway just thought that if possible i’d go to this 1 ready armed just in case.

    Andy

    March 2, 2011 at 2:24 pm #345774
    Specialist01269
    Participant

    Re: Hotpoint WDL520P

    Went to look at this 1 today after Mr Wayne 😀 The reason for it being dead (No motor action) was that the motor plug was mysteriously hanging out, The original fault (No dry heat) had’nt been sorted, he’d just disconnected the wiring & left the bare terminals in mid air. 1 of these had touched Earth which was what cause it to trip out.
    Replaced drying element, Re-fit Motor plug & everythings hunky dory now.Noticed on this 1 as well that there’s no sealant on the Heater Duct where the 2 halves join together.

    Thanks Again Jim 😀

    Andy

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.