Bosch Exxcel SGS66A02GB/20 – Suppressor blown?

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Bosch Exxcel SGS66A02GB/20 – Suppressor blown?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 28, 2011 at 7:42 pm #61366
    CurlyKate
    Participant

    Hi

    My dishwasher has recently started occasionally blowing the plug fuse. Last time it blew with 5 mins to go on the cycle. When I replaced the fuse as soon as I plugged it back in there was a loud bang…

    After a bit of digging around on here I have taken the right side off and have been looking for soot around where the mains power comes in. Where the power comes in looks fine, however if I follow the neutral wire to the next component a square block – capacitor(??) I see soot around it – what is this bit and how on earth do you access it to replace it?

    All help very gratefully received

    Yours hopefully
    Kate

    February 28, 2011 at 7:50 pm #345858
    suedehead1
    Participant

    Re: Bosch Exxcel SGS66A02GB/20 – Suppressor blown?

    as you said in the title its a suppressor,
    there may be a plate at the back which clips on where you can access it failing that skin you knuckles from the side panel just make sure the plug is out.

    March 1, 2011 at 8:05 am #345859
    CurlyKate
    Participant

    Re: Bosch Exxcel SGS66A02GB/20 – Suppressor blown? Access!

    Hi again,

    Thanks for the reply. Sadly there’s no access plate to remove. I can see 4 little brown clips poking through to the back – I assume they secure the suppressor to the back of the machine together with a screw above it?

    I can’t really see how you can access the area enough to get it in/out – any words of wisdom anyone?

    Thanks
    Kate

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.