- This topic has 1 reply, 2 voices, and was last updated 15 years ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
-
Posts
-
E40 fault, pre-ceeded by “tripped fuse”. Not able to talk to customer until later today so I don’t know if it tripped rcd/mcb or blew a fuse – I never took the original call. I’ll clarrify later as machine is in external outhouse – no obvious consumer unit.
Door lock appears to be ok – it certainly locks/unlocks as it’s supposed to.
I tried to get this into test mode but I couldn’t for some reason. Maybe I’m just being a bafoon today….
Checked for poor insulation, both heaters and motor ok.
Haven’t been able to pull the pcb out but did manage to re-seat some of the connections… WD not a lot of room.
Set programme and start – locks, pauses and E40….
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.