How to do a test program on a zan zwd1681w

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › How to do a test program on a zan zwd1681w

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • March 18, 2011 at 12:03 pm #61727
    streetlighter
    Participant

    Hi all
    Ive got the above w/d which is stuck in e90, I have cleaned and tightend both ends of the blue link wire between boards no change. I have both boards out and am checking them and wires to them but all looks ok.
    Can someone tell me how to start diag test on this machine to see if that helps ?
    Thank you
    Paul

    March 18, 2011 at 1:37 pm #347394
    streetlighter
    Participant

    Re: How to do a test program on a zan zwd1681w

    Just been to this The real fault code is e94 (config)? can I reset the config on this modual, do I need any special programer to do it? or should I get a new board (can I config the new one?)
    Ta
    Paul

    March 18, 2011 at 1:47 pm #347395
    Martin
    Participant

    Re: How to do a test program on a zan zwd1681w

    Email me your email address and I’ll send you some stuff. 😀

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.