Whirlpool AWG349/3 not finishing spin

This topic has 3 replies, 2 voices, and was last updated 15 years ago by pmb.

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
March 27, 2011 at 7:19 pm #61908

pmb
Participant

Hi i have a Whirlpool AWG349/3 which i repaired a dry joint on the main pcb (the machine was just locking the door and not doing anything else). The machine now goes through the wash and rinses but won’t finish the final spin, it spins for a few minutes(i would say a full spin time). The machine then stops spinning and pumping for a few moments then starts distributing and then spinning again. It continues doing this until it is turned off. I have checked brushs, heater and water valve they are all fine. Would this be a timer fault or main board? any help would be really appreciated
Thanks Peter

March 29, 2011 at 8:15 am #347984

pmb
Participant

Re: Whirlpool AWG349/3 not finishing spin

Has anyone got any ideas on this please? it would be really appreciated thanks

March 29, 2011 at 11:40 am #347985

Martin
Participant

Re: Whirlpool AWG349/3 not finishing spin

Can’t help you much on this except to suggest that maybe the pressure/airchamber could be crudded up perhaps?

March 29, 2011 at 4:19 pm #347986

pmb
Participant

Re: Whirlpool AWG349/3 not finishing spin

Thanks Martin i must admit i didn’t check that, i kind of assumed that as it was spinning it would be clear. I will try that but if it doesn’t work i will give up i think, the module and timer are to expensive to gamble on.
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.