Miele W821 W/M Rinse Hold error code

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Miele W821 W/M Rinse Hold error code

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • April 10, 2011 at 9:58 pm #62158
    Poppins
    Participant

    This machine is flashing the rinse hold light when it is about to spin.

    Does anyone know what code it is?

    Many thanks
    Chris

    April 11, 2011 at 6:42 pm #348961
    Seamy
    Participant

    Re: Miele W821 W/M Rinse Hold error code

    Rinse l.e.d flashing denotes drive failure, check the usual, carbon brushes, cable connection to motor etc.

    April 12, 2011 at 6:23 am #348962
    Poppins
    Participant

    Re: Miele W821 W/M Rinse Hold error code

    Thanks for that Seamy.
    It must be cable then as it doesn’t always have a problem spinning although I will check the brushes as a matter of course anyway.
    Do you know if it can be affected by the door interlock as I suspect there is a problem there as it doesn’t always engage when trying to close the door and consequently the ON light doesn’t come on? I was wondering if this could be happening in the cycle. I few flicks of the catch seems to do the trick when it plays up.

    April 12, 2011 at 7:46 am #348963
    Seamy
    Participant

    Re: Miele W821 W/M Rinse Hold error code

    door may just need a smear of grease on latch/catch, just check that door pull cord that goes down to filter door isn’t catching on anything as this can cause fault described

    April 13, 2011 at 6:54 am #348964
    Poppins
    Participant

    Re: Miele W821 W/M Rinse Hold error code

    Thanks again Seamy.
    Do you know if Miele carbon brushes are easy to get hold of? I haven’t been able to find any type on Connect, Qualtex or Europarts.

    April 13, 2011 at 7:37 am #348965
    don
    Moderator

    Re: Miele W821 W/M Rinse Hold error code

    Carbon brushes 4297412.

    Listed on Connect but special order only, part number not recognised by Qualtex I’m afraid 🙁

    Don

    April 14, 2011 at 6:37 am #348966
    Poppins
    Participant

    Re: Miele W821 W/M Rinse Hold error code

    Thanks Don
    🙂

    April 14, 2011 at 6:39 am #348967
    Poppins
    Participant

    Re: Miele W821 W/M Rinse Hold error code

    Don, is this the part number for the brushes for this specific Miele model or is it the same across them all? I havn’t seen many!! 🙁

    Chris

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.