miele W937

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › miele W937

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • April 19, 2011 at 4:41 pm #62327
    domesticbliss
    Participant

    Hi, mean beastie of a machine but has the `rinse 3` lamp flashing..machine will only do a drain and spin.. not seen this one before. any ideas would be more than welcome.
    By the way LOVE the new site and layout, well done.
    Paul

    April 20, 2011 at 10:47 pm #349691
    leavemetogetonwithit
    Participant

    Re: miele W937

    Isn’t rinse light flashing no feedback from tacho = brushes usually?
    Mike.

    April 20, 2011 at 10:55 pm #349692
    steve1
    Participant

    Re: miele W937

    faulty control module

    April 21, 2011 at 8:57 am #349693
    domesticbliss
    Participant

    Re: miele W937

    Hi and thanks for your input. usually flashing rinse light does point to either/ and direction control relay on module board which also blows the 6.3A fuse on same board, preventing the motor from working.
    However, this machine spins fine, brushes are ok. there are TWO rinse lights, rinse 1 and 2 and a rinse 3 lamp, which is the one flashing..NO water is taken in on any cycle but will drain and spin…
    any more input would be appreciated.
    Paul

    April 21, 2011 at 9:04 am #349694
    steve1
    Participant

    Re: miele W937

    hi paul
    I have had this problem before, in my case it was the module board,put in a replacement board, all ok

    steve

    April 21, 2011 at 9:05 am #349695
    domesticbliss
    Participant

    Re: miele W937

    Thanks steve, do you happen to know which part of the board failed? is it temp related?

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.