Hotpoint wmd 960 no motor

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint wmd 960 no motor

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • April 26, 2011 at 5:03 pm #62438
    allan73
    Participant

    I went out to a Hotpoint wmd960 with no motor the other week.I cut the dodgy motor plug off and refited with insulated amp tags and sure enough motor kicked into life ❗
    Today I was recalled to said m/c with same fault and customer say’s it sticks on 1 min, however when I attended m/c was working fine. I checked wiring from module to motor, seems fine any thoughts ?

    Allan.

    April 27, 2011 at 6:07 am #350125
    allan73
    Participant

    Re: Hotpoint wmd 960 no motor

    Just had a thought on this, but I could be off the mark….could the heater going to earth after it’s been on a while currupt the board and cause no motor ?


    Allan.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.