MIELE W404

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › MIELE W404

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • May 16, 2011 at 1:25 pm #62821
    MDE
    Participant

    Hi all, Odd one this,I fitted brushes to this washing machine last week and on testing it afterwards it looks like its not taking in enough water, When I put it on it takes water in for 10 seconds,pauses, and then 8 seconds but the water level is below the drum. There is a button to increase the water level and when you push it the level looks about right.The bottle is not blocked and the valve is ok,Pressure switch is a part of the control board. Any thoughts on this would be appreciated.
    Thanks Mark.

    May 16, 2011 at 6:43 pm #351412
    Seamy
    Participant

    Re: MIELE W404

    Some of these have load sensors on the suspension leg, it should take in more water if it senses a bigger load, the water level sensor/pressure switch and this load sesor can be recallibrated if needed, maybe some of the Miele engineers will post details.

    May 20, 2011 at 12:50 pm #351413
    MDE
    Participant

    Re: MIELE W404

    Thanks Seamy, I went back to try a bigger load on this but it made no difference, they are using it with the high water level buttin on at the moment.

    Thanks Mark.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.